The Lancer will be sold without the bottles since it fit any of CarPro bottles,
PROFESSIONAL FOAM LANCE – Users Manual
The professional Foam Lance allows you to obtain high pressure water mixed with detergent, producing foam.
The Professional Foam Lance has many design features to allow the user to spray varying distances while
creating a wide range of consistencies of foam. By twisting the External Plastic Body/Nozzle (#20) you can
create a wide fan flow or concentrated direct flow spray pattern. By twisting the adjustable air intake knob (#9g)
you can increase or decrease the consistency of the foam produced.
Overall foam consistency or concentration can be regulated by using various concentrations of detergents in the
one liter Detergent Tank (#1). It is important to note that the final consistency of foam of produced by the
Professional Foam Lance is primarily determined by the type of detergent utilized in the Detergent Tank. User
should try varying types and concentrations of detergent to reach the desired foam results.
The foamer may now be connected to a properly set up high pressure cleaner operating at a maximum of 5.6
gpm @ 2600 psi with included pressure regulators and safety and temperature relief devices.
Use only fresh, clear water. Ask our technical office before using special or corrosive fluids.
It is recommended that pressure washer regulator/unloader be adjusted to a lower pressure/flow setting at initial
foamer installation and then adjusted to reach optimal performance/operation. Remember concentration and
consistency of foam will depend upon type and concentration of detergent utilized in detergent bottle and also
the flow/discharge of the pressure washer and settings utilized on the Professional Foam Lance.
When user has finished with each use of the Professional Foam Lance it is important to completely rinse the
spray head and detergent bottle and suction tube with clean, clear water to assure correct operation the next
time the Foam Lance is used.
WARNING: Check that the Professional Foam Lance is compatible with the system’s functioning data in order
not to overcome the maximum values of pressure, flow and temperature indicated into this manual (see
Installation must be exclusively done by skilled workers. The Manufacturer is not responsible or liable for any loss or damage arising from a bad installation or done by unskilled workers.
Causes and remedies for possible problems:
Problem Possible cause Solution
Foam lance’s leakage Presence of dirt/debris clean
Worn seals change the seals
Flow not elevated Hole obstructed nozzle Clean the nozzle removing dirt
Dirty filter Rinse with water
Note: If you required any other foam lance adapters, please contact us: